All of the models in the new CoolForce series are designed for the fans of water-cooled systems and offer a wide range possibilities for water-cooling radiator and other components installation. On the other hand, the case offers a very elegant front design combined with pre-installed LEDs, which make the product a real eye-catcher.
The case itself is designed as a Midi Tower with dimensions of 495 mm (H) x 207 mm (W) x 525 mm (D) and weight of 9.4 kg. The materials used are SECC for the steel body, while the front panel is made of plastic. Also there are dust filters behind the front panel and on the bottom of the case and inside the case there is Bitumen for noise insulation.
Nanoxia CoolForce 1 is made to be a host for up to 7 expansion cards and:
- motherboards according to the ATX, M-ATX, Mini-ITX standards
- 2 x 5.25 inch external drives
- maximum 5 x 2.5 inch internal drives
- maximum 3 x 3.5 inch internal drives
- CPU coolers with maximum height of 165 mm
- VGA card with maximum length of 285 (425) mm
On the left side of the I/O panel ,which is located on the front part of the top panel there are 1 x USB 3.1, 2 x USB 3.0 ports, LED on/off button – allowing to turn off the Rigid LED strips. Located in the right side are the HD-Audio connectors and the three-step fan control (5V, 7V, 12V). Power- and Reset-Button are placed in the middle.
The cooling of the case and all of the hardware inside is done via 2x 140 mm fans behind the front panel, 1 x 120 mm fan located on the rear side and if the AirCover is removed, up to 3x additional 120 or 140 mm fans can be installed under the top. One 120 mm can also be mounted at the bottom of the case.
If the AirCover is removed, up to three additional 120 or 140 mm fans can be installed under the top and if the rail for the HDD-Cage on the bottom of the case is removed, a further 120 or 140 mm fan can be installed. Through this, the CoolForce 1 can be a home for up to seven fans.
The pre-installed 3-stage fan controller allows to control up to three case fans, which allows an individual compromise between low system temperatures and the lowest possible noise level can be achieved, even with a full fan assembly.
Also for all those water cooling enthusiasts, the CoolForce 1 supports complex water cooling systems. Behind the front panel, there is enough space for 280 mm radiators or compact water cooling solutions and under the top cover, users can install 120, 240 or 360 mm radiators without any problems.
For the installation of radiators behind the front, there is sufficient space for slim radiators with fans, when the HDD-Sleds are used. By simply removing the sleds, ultra-thick radiators in push/pull configuration can be used.
The top cover has special, laterally offset mounting points that allow maximum compatibility, especially when using particularly thick radiators. At the top of the case, 65 mm space is available between the upper edge of the motherboard and the case top.



